• English
  • Spanish
  • Chinese

Machine Listing - Two Drum Winders

IEC 126109
Speed 2000 FPM
Type Two Drum Surface Winder
Manufacturer Cameron Machine
Model Type 18
Capacity 150" W x 40" Diameter
Equipment Class Used Slitter Rewinders

  150” Cameron Type 18, 2-drum surface rewind, single shaft slitter rewinder. Most recently slitting & rewinding paper, nonwovens, Tyvec products. Manufacturer’s brochure indicates speeds up to 2500 FPM, depending on product being slit & rewound. Automatic counter-weighting controls of the rider roll pressure. Decreasing the pressure uniformly as the diameter of the rewound roll increases. Cameron 18 has drum grooving; designed to remove wrinkles in the traveling web. Score cut slitting done on platen roll. Maximum rewind is 40”. Typical minimum slit width when using score cut slitting is 3”. Winding drums, 13.6” dia. Roller bearings. Platen score cut roll, approx. 9” dia. Rider roll is 8.4” dia.; driven by a belt. Idler roll, 10.5” dia. Single position unwind stand, 52” dia. rolls. +/- 2” of edge guiding. Manual skew adjustment on unwind. (3) idlers mounted after unwind. (1) 8” dia., 151” wide skew roll, mounted on rewind section. Score cut slitting. Air-loaded knives. (5) score cut knives are included. Manual lift of rider roll. Manual lift of rewind shaft. (1) 2” air rewind shaft. Machine includes 2-ton hoist system which can be used in front or back of the machine. Nip guard. Autonics electronic counter. Drive motor & controller are relatively new; less than 10 years old. Baldor controller, AC, variable speed. Model H2 inverter drive, 460 volt, 3 phase, 60 cycle. 40 HP Siemens AC drive motor, 460 volt, 3 phase, 60 cycle. Typically used for paper, Tyvecs, nonwovens, fabrics.